Users browsing this thread: 2 Guest(s)
Edit Chainsaw codes
04-16-2020, 12:47 PM
(02-27-2020, 03:38 PM)Warrax Wrote: Look for Painful Chainsaw by Michael Springer (T.Geiger).Didn't see this until today. I must had done something wrong with asm. I know the bottom starting 2B4A used the original chainsaw code, but what do you mean "This line must changed"?
Source: http://geigercount.net/crypt
However, don't use the patch from that site as it causes a bug with Drill, use this bug fixed code instead:
Code:C2/2B24: 35 2B (New Drill pointer, this line must be changed)
C2/2B30: A99E LDA #$9E
C2/2B32: 8DA911 STA $11A9 (Use effect 4F)
C2/2B35: A920 LDA #$20
C2/2B37: 0CA211 TSB $11A2 (Set ignore defense)
C2/2B3A: 60 RTS
C2/2B3B: 208D38 JSR $388D (Use “Slice” subroutine)
C2/2B3E: A5B5 LDA $B5
C2/2B40: C902 CMP #$02
C2/2B42: D005 BNE $2B49 (Check for command == “Magic”)
C2/2B44: A908 LDA #$08
C2/2B46: 8D742D STA $2D74 (Set animation to “kill mode”)
C2/2B49: 60 RTS
C2/2B4A: EAEAEA
C2/2B4D: EAEAEA
C2/2B50: EAEAEA
« Next Oldest | Next Newest »
|
||||
Users browsing this thread: 2 Guest(s)