Users browsing this thread: 1 Guest(s)
Addresses After Editing Events
07-20-2020, 06:12 PM
(07-20-2020, 09:29 AM)madsiur Wrote: Any event must start in the $CA-$CC banks because of what event offset can take NPCs / event triggers. However you can insert a B2 command in banks $CA-$CC that let you call an event routine elsewhere in the ROM and continue your event anywhere past bank $CC. And yes, normally you would overwrite the bytes when editing something instead of inserting them to not shift everything after.
Okay, thank you. I saw the B2 command and wondered if that was good to use if I wanted to extend an existing event while preserving the integrity of the data surrounding it.
« Next Oldest | Next Newest »
|
||||
Users browsing this thread: 1 Guest(s)