Users browsing this thread: 1 Guest(s)
Small, unnamed event project
03-27-2012, 08:37 PM
To place a character on a certain map, you must use the command D5 in his/her action queue. And when looking for the coordinates, it's best to use LE as a guidance. Open LE, then open the desired map, and get the coordinates.
Note:This next part will serve as an example!
Suppose Arvis is NPC # 1E on your map. And you want to place him at position (2E, 32). And you want him to appear looking to the south.Then the code you must use will look like this:
The CE action can be either omitted or changed to anything else, depending on your liking.
Hope this helps! Looking forward to the video!
Note:This next part will serve as an example!
Suppose Arvis is NPC # 1E on your map. And you want to place him at position (2E, 32). And you want him to appear looking to the south.Then the code you must use will look like this:
Code:
1E 05 - Perform the following actions for character 1E (don't pause)
D5 23 32 -Place character on map on position (2E,32)
CE - look down
FF - End queue
The CE action can be either omitted or changed to anything else, depending on your liking.
Hope this helps! Looking forward to the video!
« Next Oldest | Next Newest »
|
||||
Users browsing this thread: 1 Guest(s)