Users browsing this thread: 1 Guest(s)
Attempting to create a new event command
04-05-2015, 01:22 PM
If your custom command mimics gen action C0 (at C0/B2C8) Then after the command, and the val to check you enter the destination, in reverse, as m06 said. The command should be set up to check var then read the following code as an address.
In other words, why would you need a jump command during usage of the custom command. That should already be set up in the custom code. Or am I on the entirly wrong planet?
In other words, why would you need a jump command during usage of the custom command. That should already be set up in the custom code. Or am I on the entirly wrong planet?
The only true wisdom is knowing you know nothing.
« Next Oldest | Next Newest »
Users browsing this thread: 1 Guest(s)