editing tools (chainsaw, drill, flash, ...)

So to set sleep you would do the following. I'm not sure about changing the targeting to multiples enemies:

I haven't tested it, but wouldn't it be just a matter of setting the bits here with the targeting you want?

Code:

$11A0 : Targeting Byte (Bit 0 = Cursor Moveable, 1 = One Side Only,
                            2 = Autoselect both parties, 3 = Autoselect one party
                            4 = Auto Confirm, 5 = Manual Party Select,
                            6 = Cursor Start on Enemy, 7 = Randomize selection)