FF6LE Rogue CE / Zone Doctor CE

While trying to check exits, I found a bug. If after expanding the ROM data, saving and quitting the editor, you reload your ROM and enter the expansion setting window again and press ok, your memory byte will be set to $00, thus preventing the editor to load expanded map names. This mean the map list will stop at ID $19F. You can manually set your memory byte (default at $ED747F) with the following flags in the meanwhile version 0.5 comes out:

Code:

0x01    5 banks of tilemap data
0x02    6 banks of tilemap data
0x03    7 banks of tilemap data
0x40    was using FF6LE+ or Zone Doctor+ before
0x80    expansion done

As an example, if you expanded with 6 banks of tilemap data, your byte will be $82. If you were coming from FF6LE+ with 7 banks of tilemap data, the byte will be $C3.

Edit: @Warrax, I tried location names change on Expansion maps and original dummied ones ($10B used here) and they both show location names using short and long exits. I think the map has to be loaded again to reflect the editor changes. As an example changing exit properties and loading a savestate on the map the exit is will not reflect the changes I think.