Bridge Correction patch

This thread here explains the process, I'm not sure if you've seen it:
https://www.ff6hacking.com/forums/showth...decompress

You can find a comprehensive list of the battle backgrounds from Lord J's website:
http://www.angelfire.com/pq/jumparound/

*Although not all of them are labeled, most of them actually. So you'll have to just keep trying them all until the background graphic(s) you wish to edit show up there in Peer Sprite Viewer, and it can be a bit tricky and tedious to tell what it is without decompressing it and looking at it in YY-CHR.

One thing that might have gone wrong for you is the offsets are with a header, so your ROM might have not been so when you went to 'click to buffer' it would give you a 'bad compression packet' error, since the start-end address was off.

In YY-CHR, once you load up the decompressed graphic, make sure you are looking at it with 4BPP SNES and it will show up there to edit. You just gotta be somewhat careful when editing to not go over the amount of bytes it will take to re-compress it in, basically by not going over the original's boundaries, or when re-compressing the file back in it will give you a 'bad compression packet' error, which is annoying. Different colors used too seem to take up different space, for some reason I've noticed.

* a much more comprehensive list documentation was done by Rydel and can be found here:
https://www.ff6hacking.com/forums/showth...500&page=3