Users browsing this thread: 1 Guest(s)
PC Command Edit - targeting
12-06-2015, 03:52 PM
I've changed the command Possess so that it redirects to the MagiTek code, runs it, then pulls up a seperate menu of spells using the MagiTek battle window.
All of that works fine, selecting a spell and trying to use it works as well with the pointer going to the proper position and letting me select the player or enemies it should based off the target list I provided it.
After the spell is cast it ALWAYS comes up "miss" and always on one of the two enemies, no matter how it was targeted before casting.
I had this problem before, while running the same type of deal using the summon command but never figured out exactly what fixed it.
Any suggestions or advice?
All of that works fine, selecting a spell and trying to use it works as well with the pointer going to the proper position and letting me select the player or enemies it should based off the target list I provided it.
After the spell is cast it ALWAYS comes up "miss" and always on one of the two enemies, no matter how it was targeted before casting.
I had this problem before, while running the same type of deal using the summon command but never figured out exactly what fixed it.
Any suggestions or advice?
The only true wisdom is knowing you know nothing.
« Next Oldest | Next Newest »
|
||||
Users browsing this thread: 1 Guest(s)